Direct approach, just go to the BROADCAST tab, enter the rate or signature inside the SIGNATURE field, type how many seconds in the SECONDS field and click on BROADCAST NOW.
The “multiplier” represents your intention to force it. But be aware, that this is not good practice every time or for each target. The gentle stimulation is always preferable.
You can broadcast an entire list. Click on BROADCAST LIST and select your own list or one from the data folder.
Or you perform ANALYSIS in the ANALYZE tab and BROADCAST MIX every rate that is green (higher GV than the target).
There is also a AUTO MODE ON button. I use that personally if a very very gentle approach is required and the target seems to be “close” (not reachable). After that the link normally can be established a lot easier.
Or just press the BROADCAST button of the corresponding rate. It will broadcast it depending on the GV difference or for the entire time, depending of your settings.
The full manual can be read here.
Radionics 