The source-code can be downloaded from the Github project https://github.com/isuretpolos/RadionicsProtocol.
Take a look at the LED definition. You need one for the coil and five for the LEDs. The coil is better combined with a LED, so you can visually determine if it works.
The project is a work in progress. Stayed tuned for more updates.
Radionics 
Suggestions:
1) the more closer you put the neutral substance to the coil THE BETTER.
2) I see 3 thick walls of plastic between the pills and the coil (the plastic container, and other two red plastic walls). The plastic walls will act as an insulator. Find a way to put things closer to the coil.
3) Since ardruino has an output of 5 volts max, the the coil you did is for a 12″ large speaker sub woofer that will require an amp at least of 1000 watts to power it up. Ardruino by it self will not do the job.
4) I suggest that you do another coil , smaller on length, lots of loops, you can doit double layer and you will get way much better results for printing radionic remedies.
Check this amazing video, it will give you lots of tricks for coil building. https://www.youtube.com/watch?v=6qjcIXaE7gc
Maybe I can send you a schematic of some designs that work best for me over the past 15 years, they will save you lots of of time.
WHAT HAPPENED TO THIS PROJECT of yours? this you finish the code ? Best regards
LikeLike
I forgot to THE MOST IMPORTANT TIPS for coil making like a RADIONICS MASTER are:
1) For output cup / output printing/ remedy making coils: must be be ⟲ ANTICLOCK WISE gaped (to the left, like walking down a spiral stairs). remember that ALWAYS ANTICLOCKWISE for printing and broadcasting. The cooper wrap that way rise an POSITIVE electromagnetic for printing, proyecting or broadcasting.
2) For input cup / sample reader, the coil must be ⟳ CLOCKWISE gapped. (to the rigth). Rigth wrapping rise a NEGATIVE electromagnetic field used for reading, substracting info.
***Is a little confusing when building the coil and even the most expirienced users make mistakes , so take your time when building it.
3) By the way, ALWAYS PUT some hand gloves you dont want to left your finger prints all over the coil that will broadcast to you all the future remedies you print in that coil
4) Materials: over the years I try other materials for the coil searching for the perfect coil for radionics, I’ve found that the best coils have zinc on it. This mineral rise the conductivity of the coper making it the ideal material for radionics, Brass is made from an alloy of Copper and Zinc and i highly recomend to get your hands on some brass wire (insulated)
Enjoy
LikeLike